2-in-1 Screw Extractor, time-saving rapid removal
No pre-preparation required !!
* 1st Bit requires no hammer. Simply press down on the screw & twist it out!!
* 2nd Bit features a sharp blade that is hammered into the stripped screw recess.
* High-torque handle grip - standard 6.35mm (1/4") hex drive
1st BIT Press & Twist !!
4 edges of the cross tip can firmly grip
the remaining corners of Phillips recess.
Screws slightly damaged
Insert the 1st Bit into the handle grip and grip it as illustrated below.
Place the bit tip into the screw head, then scrape away burs in the recess by twisting it back and forth lightly.
Do not attempt to hit the 1st Bit with a hammer.
After you feel the bit tip catches the corner of recess,
give a jerk counterclockwise while pressing firmly downward.
2nd BIT Strike & Turn !!
Sharp and durable blade can stick into the screw recess easily for secure grip.
Screws heavily damaged or failure with the 1st Bit.
Clean out any steel chips left in the screw recess.
Fix the rubber sleeve to the 2nd Bit and position the blade in the recess.
Strike the end of the bit with a hammer to stick the blade into the recess.
Make sure the bit is self-standing upright, and then affix the grip onto the bit.
** Do not hit the grip with a hammer.
Give a jerk counterclockwise while pressing firmly downward.