==FEATURES== ●Interchangeable die set for open-barrel contacts.
Easy replacement and perfect fitting to frame
●Ergonomically-designed handles with strap hole
●Equipped with wire stripper and cutter ●2.5mm (Across flats) Hex key wrench included as standard accessory ●Material -
Frame & Die set : Special alloy steel
Handles : Elastomer (TPR)
** Before use, please make sure that wire size meets the standard provided by each connector maker and that the configuration and size of terminal is adaptable to the crimping dies.
** Adjust both wings of open-barrel to be in parallel before crimping.
** Make sure that connector pin retains straight before insertion into a die cavity.
** Do not lay the contact pin inclined in a die cavity to avoid deforming in crimping work.
** Do not squeeze handles so hard while crimping insulation portion, which may cause disconnection of wires.
HOW TO ADJUST JOINT-SCREW
When Joint-Screw gets loose,
Hold the hex bolt
(Reverse side) with a wrench.
Fasten the joint-screw
with a hex key wrench.
(Torque less than 2 N/m)
=CAUTION= Do not attempt to adjust the bolt with nut
from both sides with 2 pcs. of wrenches, which causes the screw joint broken. Use a hex key wrench for fastening with
torque of less than 2 N/m.
INTERCHANGEABLE DIE SET
Over 300 crimping of various open-barrel contacts applicable by assortment of 3 different die sets